Table of Contents
Advertisement
Section 2: Installation and Setup
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB signal, specify this Color Space
option within the Image Settings menu. Refer to
signals (such as from DVDs or analog HDTV sources) to
described in
2.4.2 YPbPr (Component Video)
Connect a YPbPr signal (a.k.a. component video) to INPUT 1 or INPUT 2 as shown in
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal, specify this Color Space option
within the Image Settings menu. Refer to
component signals (known as YCbCr) to
installed at
2.4.3 Composite Video
INPUT 3 and INPUT 4 provide simultaneous connection of both a composite video source (INPUT 3) and an
S-Video source (INPUT 4). Refer to
2-20
Figure 2-28 Connecting RGB Input
Section 2.4.2 YPbPr (Component Video)
.
INPUT 5 or 6
Figure 2-29 Connecting YPbPr
Figure
Section 3.5 Adjusting the
INPUT 1
(below).
Section 3.5 Adjusting the
. Use the appropriate digital interface option
INPUT 1 or 2
2-30.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
Image. 2) To connect YPbPr
, use the red, green and blue BNCs as
Figure 2-29
Image. 2) Do not connect digital
020-100002-06 Rev. 1 (04-2011)
.
Advertisement
Table of Contents
