Christie Mirage S+/HD/WU User Manual page 141

5. REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector. See
lamp using safe disposal/recycling practices.
6. INSERT THE NEW LAMP MODULE
Align the base plate of the new lamp module under both side
alignment guides (see
the projector in the same orientation you removed the old lamp
module. Push with normal force until the resistance increases,
then firmly push module another ½ inch.
NOTE: The lamp module must make full contact with the lamp
connectors. Increased resistance when sliding the module
in indicates initial contact with these connectors-push
firmly at this point.
meltdown inside the projector.
7. RE-INSTALL LAMP RETAINING BAR
Position the retaining bar along the bottom edge of the lamp module, with its ends under the alignment
guides. If the bar does not fit, push the lamp module further in. See
IMPORTANT!
• Secure screw B until just engaged.
• Secure screw A until just engaged.
• Go back and forth between A and B to lock the bar in place with even pressure and correctly position the
lamp module.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Figure 4-4 Remove Lamp Module
Figure 4-5). Slide the module fully into
Improper installation could cause a serious
The tightening order of the screws is critical for proper lamp contact and alignment.
Section 4: Maintenance
Figure 4-4. Discard the
Figure 4-5 Right Alignment Guide
Figure 4-6.
4-7