Christie Mirage S+/HD/WU User Manual page 120

Section 3: Operation
6. In each projector, judge by eye and adjust x/y coordinates slightly in the following manner:
• To match reds, decrease " Red X" until full field red
screens match.
• To match greens, decrease "Green Y" until full field
green screens match.
• To match blues, increase both "Blue X" and "Blue Y"
until full field blue screens match.
NOTE: For speed, enable the "Auto Color Enable"
check box. Each color coordinate you select
automatically triggers a full field display of the
corresponding color.
Alternatively, use the Color Saturation menu for these adjustments or to fine tune.
These coordinate adjustments move the 3 color points closer together (refer back to the chromaticity chart
shown in Figure
as necessary to ensure the resulting color palette is as large as possible. When done, you may need to adjust
lamp power slightly.
7. All screens should now be color-matched. Apply this new "User" gamut to a source at any time by
selecting it in the "Select Color Adjustment" list accessed in the Advanced Image Settings menu.
Using the Color Saturation Menu for Color Matching
You may prefer to use the Color Saturation menu to match colors across multiple screens. In the 3 Color
Adjustment submenus (Red, Green, Blue. See
values to "0". Then judge by eye and adjust the slidebars as needed.
NOTE: Adjustments here define new x/y coordinates in the Color Adjustments by X, Y menu.
For best results, the Color Adjustments by X, Y menu should be used first.
3-68
Figure 3-41 Copy X/Y Values into All Projectors
3-32) to establish a "shared" gamut attainable by all projectors in your group. Adjust only
Figure 3-42) set all main values to "100" and the secondary
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)