Christie Mirage S+/HD/WU User Manual page 27

3. Extend the 3 stacking legs.
Extend the stacking legs (3) by turning them so that at
least 1 inch of thread is visible on each. This clearance
accommodates the up-or-down movement for aligning
the images from the stacked projectors. Ensure that you
extend all 3 legs equally (see
level.
• If upright, extend legs on top projector (shown)
• If inverted, extend legs on bottom projector
IMPORTANT! Extend the stacking legs equally by at least
1 inch.
4. Loosen the rear stacking leg nuts
On the rear stacking legs
the nuts so the legs have some lateral
movement for easier alignment with the
stacking mounts on the other projector.
• If upright, release on top projector
• If inverted, release on bottom projector
5. Release and remove three safety pins.
The 3 safety pins must be removed from the stacking mounts so that
the stacking legs can fit into the mounts
• If upright, remove the pins from the mounts on the bottom projec-
tor
• If inverted, remove the 3 safety pins from the mounts on the top
projector
6. Place top projector on bottom projector.
With 1 person on each side, lift the top projector on to the bottom
projector, aligning all 3 stacking points between projectors. The legs
(4) should fit inside the stacking mounts.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Figure 2-12) so they are
(Figure 2-13), loosen
Minimum of 2 people required.
Figure 2-13 Loosen 2 Nuts
(Figure 2-14).
Section 2: Installation and Setup
Figure 2-12 Extend 3 Stacking Legs
(UPRIGHT STACK SHOWN)
Figure 2-14 Remove Safety Pins
2-9