How Old Is My Lamp; Lamp Replacement Procedure - Christie Mirage S+/HD/WU User Manual

Table 4.2 Lamp and Filter Kits
Projector Model
M WU18 (104-065113-
IRAGE
R HD18K (104-021101-
OADSTER
R HD18K (104-021137-
OADSTER
R HD18K (104-021126-
OADSTER
R HD18K (104-021115-
OADSTER
R S+20K (104-001101-
OADSTER
R S+20K (104-001135-
OADSTER
R S+20K (104-001124-
OADSTER
R S+20K (104-001113-
OADSTER
M S+20K (104-068105-
IRAGE
A bubble lamp permanently mounted inside its own protective assembly provides the high brightness of your
projector. Using this module beyond its warranted life is not recommended-changes in the quartz of the bulb
can lead to reliability problems, poor performance or sudden lamp expiry. The filter should always be changed
when the lamp is replaced, or sooner in dusty environments.
The lamp module is calibrated for maximum performance and brightness in this projector. Do not attempt to
re-align or adjust the lamp module.

4.6.1 How Old is My Lamp?

The number of hours logged on the current lamp appears both in the Lamp menu and the Status menu. In the
Status menu, do not confuse "Lamp Hours" with "Lamp Counter" which indicates the number of hours logged
during the current rental period only and is normally used for rental projectors only.
NOTE: As the lamp nears its limit (as set in Lamp Limit), a message can appear on screen to warn that the
lamp needs to be replaced. The LED's next to the built-in keypad will flash "LP" when lamp time has
expired. To ensure this warning appears, enter a checkmark in the Lamp Message check box located
in the Lamp secondary menu.
4.7

Lamp Replacement Procedure

TOOLS: A Phillips #2 screwdriver is required. All access panels' screws are ¼-turn to lock/unlock.
Replacement procedure in its entirety before proceeding.
an intense accumulation of heat called a "hotspot", which could potentially result in the lamp shattering.
It is recommended you wear clean, lint-free gloves and a face shield when working with the lamp.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
)
XX
)
XX
)
XX
)
XX
)
XX
)
XX
)
XX
)
XX
)
XX
)
XX
A Christie accredited service technician must perform lamp replacement.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Christie (see above) and read the Lamp
Do not touch the glass surface of the lamp. Fingerprints left on the surface can lead to
Lamp Type (Watts)
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
3.0 W
K
Section 4: Maintenance
Lamp/Filter Kit Required
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
003-000306-
XX
4-5