Christie Mirage S+/HD/WU User Manual page 63

and contrast settings controls, the overall tone of an image can be lightened or darkened without changing the
two extremes, and your images will be more vibrant yet with good detail in dark areas.
The normal Gamma Table setting of 2.2 is correct for most signals and conditions. If excess ambient light
washes out the image and it becomes difficult or impossible to see details in dark areas, lower the gamma
setting to compensate. This will improve contrast ratio while maintaining good details for blacks.
Menu
Press to enter or exit the projector's Menu system.
Menu
NOTE: Refer to
and associated options/submenus.
OSD (On-Screen Display)
Press + the
OS D
To see the Menu system again, do one of the following:
• Press and hold
• Press and release
• Press twice quickly
OS D
Invisible menus are fully functional, enabling "hidden" access to numbered features and image adjustments by
entering the corresponding sequence of key presses on the keypad.
NOTES: 1) With the OSD "ON", you can still hide error messages and slidebars by disabling these options in
the Menu Preferences menu.
PIP (Picture-in-Picture)
Press to enable and disable Picture-in-Picture. PIP enables you to display two different images
simultaneously, typically a smaller "secondary" image within a large "primary" background. When a menu
control or slidebar is present, press to toggle the current function to affect the other image.
NOTE: Disable PIP and Best Switching for Interlaced sources > 35 kHz.
Swap
Press to swap the current picture-in-picture relationship so that the primary image becomes secondary,
Swap
and the secondary image becomes primary.
NOTES: 1) This key is available on the "Brick" rental staging - Standard IR remote only. Alternatively, a
swap can be accessed in the Menu system. 2) Requires PIP enabled.
Shutter
Press and hold the
keystroke.
Press and release the
(shutter OFF; open) to guarantee the correct toggle (useful if you are unsure of the present state).
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Appendix E: Menu Tree, which allows you to quickly locate and navigate to a specific menu,
key to hide the projector's Menu system during use.
briefly
OS D
followed immediately by the
OS D
key briefly to toggle the internal mechanical shutter blade closed or open with a single
S hutter
key followed immediately by the
S hutter
key
key (shutter ON; closed) or the
Section 3: Operation
key
3-11