Christie Mirage S+/HD/WU User Manual page 29

Alignment Procedure:
1. Position the first image (fixed projector).
Position the fixed projector's (first) image as desired and align the other image(s) to it as described below.
2. Display the grid test pattern.
Display the Grid Test Pattern. To distinguish each image, enable "Red" for 1 display and "Green" for the
other. Refer to
3. Adjust Zoom and Focus.
Minimize each projector's zoom and images are in focus.
4. Try aligning the two grid patterns.
Adjust the Zoom and Offset on the top projector to precisely move its test pattern display on to the bottom
test pattern. When properly aligned, all red/green grid lines in the combined image will turn yellow.
• If all lines are well aligned, skip to
• If alignment needs improvement, proceed with the next step.
5. Align the centerlines of the grid.
Turn the 2 rear stacking mount wheels to move the top
projector as necessary to achieve well-aligned centerlines.
Use a screwdriver in the holes around the rim of each
adjusting wheel for better leverage and control.
How to move the image. Turn independently; each stacking
mount acts as a pivot point for the opposite edge of the
display (Figure
For example:
• Turn the right mount to tilt the left portion of the image up
or down
• Turn the left mount to tilt the right portion of the image up
or down
• Turn the mounts together to raise or lower the top image
like an offset adjustment, or turn the front stacker
If the center lines form an
projectors (and images) are slightly tilted in relation to one
another. Turn 1 mount to raise 1 side, and/or turn the other mount to lower the other side. See
If the center lines are parallel, but misaligned:
• If centerlines are out by the same amount from top and bottom, use off-
sets (on top projector) to bring the centerlines into alignment.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Section 3.2 Using the Keypads
Step 6. b.
2-16).
This indicates that the
"X".
if you need help enabling colors.
to lock all stacking mounts.
Figure 2-16 Adjustment Directions
Section 2: Installation and Setup
(Tilt)
Figure
Figure 2-17 Misaligned
2-16.
2-11