Christie Mirage S+/HD/WU User Manual page 99

Projector
Enter a 3-digit number (such as "001") to assign or change a number to the projector currently in use. If the
current projector already has a number assigned, that number appears here (for example, "004" in , above).
Numerical identity for projectors enables you to communicate with a single projector within a multiple-
projector application (see also
or changing the projector number, press
NOTE: When multiple projectors are being used and you want to adjust the color and edge blending settings
for individual projectors to create one seamless image, you must assign different numbers for each
projector to allow switching back and forth between projectors while adjustments are being made
Network Routing
NOTE: Not applicable for stand-alone projectors or simple networks with only 1 type of controller and
linking.
Separate. Select "Separate" (factory default) to keep RS-232, RS-422 and Ethernet messages on their
respective paths instead of being broadcast to the other types of ports. In
the projector to which it is connected. In
RS-232 and RS-422 Joined. Messages to and from any serial port is also relayed to all other serial ports. Use
when there is only 1 physical link between any 2 projectors, but which might be RS-232 or RS-422.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
key in Section 3.2 Using the
Proj
to cancel.
Exit
Figure 3-29
Figure 3-29 Using the "Network Routing" Option
Keypads). If you make a mistake in assigning
Figure 3-29
B; either RS-232 or RS-422 will control the network.
Section 3: Operation
A, RS-422 controls only
3-47