Removing The Status Display Control Panel Keypad - Christie M Series Service Manual

17. Remove the guide insert.
18. Remove the nine screws from the PBP.
19. Remove the PBP by pulling it up from the plate.
Two guide pins keep it in place. The guide pins securing the PBP may be tight and extra force
may be required to remove them.
20. To re-install, follow these steps in reverse order.
Removing the status display control panel
keypad
The keypad is located on the lamp side of the projector towards the front and sits directly under the
LCD screen.
Estimated replacement time: 22 minutes.
1. Remove the lamps (on page 81).
2. Remove the top cover (on page 45).
3. Remove the front cover (on page 48).
4. Disconnect wire (J78) from the keypad.
5. Remove the lamp side panel (on page 46).
6. Disconnect the flex cable from the LCD PCB located on the inside of the lamp panel.
7. Remove seven screws from keypad PCB.
8. Remove the keypad PCB.
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
65