Table of Contents
Advertisement
Section 2: Installation and Setup
2.11.1 Ergonomic Keypad
This style of keypad offers one protocol (A) only, and can be converted for wired use as
follows:
1. Using the built-in keypad, display the
Keypad option.
2. Connect the IR remote keypad to the phono jack Input labeled
projector's Input panel.
2.11.2 Standard IR Remote
NOTES: 1) Typically used for Roadsters. 2) Protocols B-G described here require main
projector software v1.2d or higher.
At manufacture, the remote keypad is assigned "A" as its default protocol, which is simply
a collection of settings that determines how the IR keypad operates. Once assigned, a
protocol remains in effect until it is changed. That is, the remote keypad will operate as it
currently does until you change its protocol. Each rental staging remote can operate using 1
of 7 different IR protocols, or it can be set to a "wired" protocol for use when a cable
connects the remote to the projector. Change protocol via "hard-wired" jumper settings
inside the keypad, set projector software to match, and add or remove the keypad cable as
necessary.
NOTE: Match the protocol on the projector to that of a remote by accessing the
Communications secondary menu. Refer to
Parameters and Advanced Controls
protocol the projector's infrared sensors (rear and front) will recognize.
2.11.3 Setting the Protocol
To convert the Roadster "Brick" rental staging – Standard IR remote from IR to wired use (or vice versa), set
its protocol accordingly. See below.
2-32
Communications
menu, and choose the Wired
Section 3.6 Adjusting System
for further information on how to define which
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
on the
REMOTE
020-100002-06 Rev. 1 (04-2011)
Advertisement
Table of Contents
