Christie Mirage S+/HD/WU User Manual page 51

1. Unlatch and open the battery compartment on the back of the keypad as shown in
Figure 2-48 Opening the "Brick" rental staging – Standard IR remote
2. Find the 4 jumpers located along the latching side of the battery compartment. These jumper settings
establish the protocol to be used so that the remote functions in a certain manner.
3. Set the jumpers to match 1 of the protocols shown in
remove and replace each jumper as necessary.
• J1 jumper: Set between 1 and 2 or 2 and 3 as required for the desired protocol.
• J2 jumper: Set between 1 and 2 or 2 and 3 as required for the desired protocol.
• J3 jumper: Set between 1 and 2 or 2 and 3 as required for the desired protocol.
• J4 jumper: For IR use,
Figure 2-49 Setting the Jumpers in the "Brick" rental staging – Standard IR remote
NOTE: Protocols B-G require v1.2d (or higher) software.
4. Plug in the keypad cable (if jumpers are set for wired use) and replace the battery compartment cover.
5. Plug into projector (wired keypad only) and test.
NOTE: If you change any keypad to a new protocol and the projector stops responding, the projector may be
set to a conflicting protocol. Use the projector's built-in keypad to access the Communications
secondary menu. Under "Front IR" or "Rear IR", select the protocol that matches the new protocol
of the keypad at hand. The projector should now respond properly.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
always
set between pins 1 and 2 (see A-G below).
Section 2: Installation and Setup
Figure 2-49. Use tweezers or needle-nose pliers to
Figure 2-48.
2-33