Section 2: Installation and Setup
For angled installations, refer to "Special Mounting" under
discussed earlier in this section.
2.10 Zoom, Focus and Lens Offset
Once the projector is properly set up and producing an image, you are ready to make quick lens adjustments.
Refer to
Section 3.2 Using the Keypads
the keypad and Menu system.
2.10.1 Lens Adjustments
NOTE: Not applicable to fixed lenses. Focus fixed lens by turning focus ring on lens.
Zoom
With the input image displayed:
• If standard IR remote: Press ZOOM +
• If built-in keypad: Press ZOOM +
Hold the ZOOM key down to see the effect – arrows in the display indicate the direction of
the zoom. See
Focus
With the input image displayed:
• If remote keypad: Press FOCUS +
• If built-in keypad: Press FOCUS +
Hold the FOCUS key down to see the effect. Arrows in the display indicate the direction of the focus. See
Figure 2-44
2-30
Figure 2-42 Adjusting the Feet Height
and
Figure
2-43.
.
Section 2.3 Projector Position and Mounting
Section 3.3 Navigating the Menus
or
or
or
or
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
if you are unfamiliar with using
Zoom
Figure 2-43
Focus
Figure 2-44
020-100002-06 Rev. 1 (04-2011)