Table of Contents
Advertisement
Channel
Press
to select a specific source setup (channel) defined, and stored in projector memory.
C h an n e l
Once you enter a 2-digit channel number (or, if there is a list displayed, highlight it, and press
display will automatically change and update according to the numerous setup parameters defined for that
channel. Note that a new channel is automatically created if you adjust an image from a new source.
NOTE: The
C h an n e l
option is enabled in the Menu Preferences menu. You can choose to use a scrollable list of channels
when you press
screen feedback. Refer to
discussed later in this section.
Input 1
Press
Input 1
to display from the data input source connected to BNCs labeled INPUT 1. If PIP is enabled,
pressing
will change the PIP source.
Input 1
Input 2
Input 2
Press
to display from the DVI source connected to INPUT 2. If PIP is enabled, pressing
change the PIP source.
Input 3
Press
Input 3
to display from the composite video source connected to INPUT 3. If PIP is enabled, pressing
Input 3
will change the PIP source.
Input 4
Input 4
Press
to display from the S-video source connected to INPUT 4. If PIP is enabled, pressing
change the PIP source.
Input 5
Input 5
Press
to display from the INPUT 5 interface module installed in the Option 1 slot.
If PIP is enabled, pressing
Dual SD/HD-SDI module is installed, the second input (B) is considered INPUT 7. Press
INPUT 7 as follows:
• While displaying from INPUT 5, press
• While displaying from any input other than the Dual SD/HD-SDI Module, press
either INPUT 5 or INPUT 7, depending on which of the Dual Module inputs (A or B) was last used. Press
again to display from the other Dual SD/HD-SDI Module input.
Input 5
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
key behavior during a presentation depends on whether or not the Display Channel List
, or you may prefer to enter the desired channel number "blind", i.e., without on-
C h an n e l
Menu Preferences
changes the PIP source. If there are 2 inputs connected here, such as if the
Input 5
in
Section 3.6.1 System Configuration (General Settings)
again. This switches to INPUT 7.
Input 5
Section 3: Operation
), the
Input 2
will
Input 4
will
to access
Input 5
. This switches to
Input 5
3-9
Advertisement
Table of Contents
