Christie Mirage S+/HD/WU User Manual page 100

Section 3: Operation
RS-232 and Ethernet Joined. Messages to and from the RS-232 ports are also relayed to the Ethernet port,
and vice versa. Any RS-422 communications are isolated.
All Joined. All messages reach all ports, regardless of type.
Ethernet Settings Submenu
NOTES: Recommended for network administrators only.
DHCP
Select this check box if you want a DHCP server to automatically change the projector's default IP address
(0.0.0.0) to 1 that is valid and unique for use on the current Ethernet network.
On networks without a DHCP server, or to simply override the automatic DHCP server function, clear the
check box, and enter the new "IP Address" settings desired. Remember that only a 0.0.0.0 address triggers the
DHCP addressing service only when the DHCP check box is enabled.
IP Address
Enter a valid and unique IP address for use on the network to which the projector is currently connected. Upon
the next power-up, this address will overwrite any previous IP address such as the projector's factory-defined
default (0.0.0.0), or 1 that has been assigned by a DHCP server or other user. An IP address entered here
remains in effect until it is changed again.
NOTE: Make sure the projector is connected to the network before changing its IP address. Make sure to re-
boot.
Port
On some Ethernet networks, firewall restrictions may require that the port number of the projector be changed
from its default of 3002. If so, enter a new valid port number here. . It is highly recommended not to use a port#
below 1024, as these ports are typically reserved by common IP applications.
Subnet Mask and Default Gateway
The Subnet Mask and Default Gateway are automatically assigned when DHCP is enabled. If a static IP is
being used, the IP must be assigned first since the subnet mask is estimated by the projector after the IP is
entered. The Default Gateway is an optional router device used to send and receive data outside the subnet.
ArtNet Interface Settings Submenu
ArtNet is an Ethernet communication protocol that was developed by Artistic Licence. It is used for controlling
lighting/staging equipment from a lighting console or PC application. It is based on the popular DMX512
control protocol.
ArtNet Subnet. This is the highest level address for a device. Typically it is set to 0.
3-48 Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)