Table of Contents
Advertisement
Section 3: Operation
3.2.4 Guide to Keypads
• Press keys one-at-a-time; there are no simultaneous key combinations required.
NOTE: Three keys: P
• Hold the A
RROW
briefly between adjustments to ensure that more distant projectors can "keep up" with the commands.
• If you press any key while the projector is still responding to the previous action, such as during power-up,
the second key press may not take effect.
3.2.5 Keypad Commands
Specific keypad commands are explained below.
Power ON/OFF
• Press and hold
• Press and release
correct toggle. This is useful if you are unsure of the present state.
NOTES: 1) After powering down, the lamp cooling fan remains on for approximately 5 minutes to cool the
lamp. 2) It is a good idea to avoid turning a projector back ON until it has been OFF for several
minutes. Hot re-strikes of the lamp may reduce lamp life.
Test
Press
to scroll through the projector's internal test patterns. When a test pattern is up, use
Te st
to scroll through the patterns without going back to the Input.
Auto
Press
Auto
to initiate an automated process in which the projector optimizes critical display parameters such
S etup
as size, position, pixel tracking, etc., for the current unlocked channel. These parameters are listed in
An Auto Setup can save time in perfecting a display, and you can further modify the settings as desired.
For WUXGA models a window will display, "
NOTE:
all except WUXGA
signal is WUXGA, choose, "
This is only used and relevant for analog UXGA or WUXGA.
NOTE: You must have an unlocked channel present to use A
3-8
, S
,and OSD. Press key once. Refer to
OWER
HUTTER
keys down for continuous adjustment/movement in one direction. In serial networks, pause
briefly to toggle the projector ON or OFF with a single keystroke or press twice.
followed immediately by the
". If your signal is UXGA, choose "
Do Auto Setup, all except UXGA
Table 3.3 Auto Setup
What an "Auto Setup" Does
OPTIMIZES:
S
B
IZE AND
LANKING
V
S
ERTICAL
TRETCH
P
OSITION
I
L
NPUT
EVELS
key (ON) or the
Do Auto Setup, all except UXGA
Do Auto Setup, all except WUXGA
". The default is "
SETS TO DEFAULT:
A
I
L
(
UTO
NPUT
EVEL
D
(
ETAIL
IF VIDEO SOURCE
F
ILTER
L
D
UMA
ELAY
S
.
UTO
ETUP
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
Figure
3-4.
key (OFF) to guarantee the
" and "
Do Auto Setup,
all except WUXGA
)
OFF
)
020-100002-06 Rev. 1 (04-2011)
and
Table
3.3.
". If your
".
Advertisement
Table of Contents
