Table of Contents
Advertisement
Section 3: Operation
3.3.7 Editing Numerical Values
Enter numbers directly from the built-in keypad or standard IR remote in order to specify numbers representing
projectors, channels (source setups), or slots. As each digit is entered, it displays and the cursor moves on.
Note that Channels are assigned 2-digit numbers. For example, if you enter only a single digit (such as "7") for
a channel number, the channel automatically changes to "07". Enter "07" to utilize this channel.
NOTES: 1) Once you enter the first digit, this digit over-writes the current entry. 2) If you press any non-
numbered keys, the number entered up to that point is accepted, and updated as the new value. 3)
Press
3.4
Using Inputs and Channels
NOTE: Refer to
projector.
The projector stores and automatically recalls up to 50 different channels (source setups) for a variety of inputs.
This memory feature allows you to define and conveniently use a wide variety of customized setups rather than
having to repeatedly re-configure the projector for different presentations. Depending on what you have
defined, each physical source connection (i.e., input source to the projector) can have several different channels
associated with it.
3.4.1 Do I Select an Input or a Channel?
Input
An Input is a source physically connected to the projector.
which Input slot (side panel) it is connected.
Switching Inputs
Press the appropriate direct
projector.
The image displays according to the following:
If it is the first time you have used the source/input (or if you used the input, but did not define a channel by
adjusting anything), the projector recognizes the new input signal based on its frequencies and polarities, and
automatically displays an image according to default settings for such a signal. In general, the image from the
3-18
Figure 3-10 Editing Text
to cancel editing of numerical values.
Exit
Section 2 Installation and
key (1 to 6) to quickly display 1 of the 6 inputs connected at the side of the
Input
Setup, for a full explanation of how to connect sources to the
describes the source signal according to
Input
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)
Advertisement
Table of Contents
