Flicker, Shadows Or Dimness; Liteloc™ Does Not Seem To Work; Ethernet; Sync Input - Christie Mirage S+/HD/WU User Manual

Section 5: Troubleshooting

5.2.3 Flicker, shadows or dimness

Increase lamp power, if possible.
5.2.4 LiteLOC™ does not seem to work
1. Ensure "Intensity" is selected in the Lamp menu. Other lamp modes disable LiteLOC™.
2. If the lamp power has increased to its maximum in order to maintain a LiteLOC™ setting, LiteLOC™ is
automatically terminated. If the values shown in the Lamp menu indicate that the lamp power has reached
this "over-drive" state, either reduce your LiteLOC™ setting or install a new lamp.
5.3

Ethernet

1. Ensure the Ethernet settings are valid for your site-all network devices should have the same subnet mask
and unique IP addresses.
2. Ensure the projector is connected to a network before you attempt to change its IP address, and always
cycle power (OFF/ON) to implement the new IP address.
3. Ensure address changes have been saved, and re-boot to implement.
4. If you still have trouble establishing communications with a projector added to an existing Ethernet
network, the projector's IP address is likely in conflict with another address already in use. Contact your
network administrator.
5.4 3D Sync Input

5.4.1 System Error Code 1E

1. Cable not connected to specify Sync Input.
2. Connect cable.

5.4.2 System Error Code 1F

1. Sync is present, but out of range.
2. Previous hook up to projector was sending Sync to Emitter. Change 3D Sync Output to Next.
5-4 Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)