Christie Mirage S+/HD/WU User Manual page 52

Section 2: Installation and Setup
Shortcut Method
Unlike older models of Christie projectors and keypads, there is no shortcut method for changing a keypad's
protocol through a special sequence of keystrokes. Simply change the internal jumper settings as described
above.
Converting a Rental Staging Keypad
If desired, you can convert this IR remote keypad into a wired remote keypad, and vice versa. Set the jumpers
as shown in Figure
To Change from Infrared to Wired
1. Remove battery compartment cover from back of the keypad.
2. Remove batteries (refer to
3. Wait 1-2 minutes. Meanwhile, notch the battery cover to create an exit hole for the cable. Ensure the hole is
smooth and will accommodate the cable without pinching.
4. Plug the keypad cable (supplied) into the empty battery compartment. Ensure the connector is oriented
correctly (red wire nearest to the edge).
5. Set the keypad's protocol to "wired" jumper setting (refer to
pins 2 and 3 as shown in
6. Replace battery compartment cover, keeping the strain relief tie just inside the battery compartment at the
exit notch.
7. Plug into the port labeled
To Change from Wired to IR:
1. Unplug the keypad from the projector.
2. Open the keypad back and unplug the keypad cable.
3. Wait 1-2 minutes.
4. Install batteries (refer to
5. Set the jumpers according to the desired IR protocol (refer back to
between pins 1 and 2 as shown for all IR remote protocols.
6. Replace battery compartment cover.
2-34
2-49. Add or delete the cable (supplied) and batteries as required.
Section 4.5 Replacing Keypad
Figure 2-49 (shaded example).
on the projector's Input panel.
REMOTE
Section 4.5 Replacing Keypad
Batteries).
Figure 2-49). Ensure jumper #4 is set between
Batteries).
Figure 2-49). Ensure jumper #4 is set
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)