Ethernet Communications - Christie Mirage S+/HD/WU User Manual

Connecting RS-422
If you wish to control the projector with a computer and or other controlling device with RS-422 capability,
connect a RS-422 serial communication cable between the computer and the RS-422 port on the projector. See
Figure 2-32. RS-422 is better suited for serial communication over long distances then is RS-232 communica-
tion.
voltage levels of this signal can damage incompatible equipment.

2.5.3 Ethernet Communications

To add the projector to an existing Ethernet network with other equipment such as controllers and other
projectors, connect standard CAT5 Ethernet cable between your Ethernet controller (or hub) and the Ethernet
port at the rear of the projector as shown in
CONNECTING TO A PC: If you are connecting the Ethernet port directly to a PC (rather than a network or
hub), ensure a crossover Ethernet cable is used.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1(04-2011)
Figure 2-31 RS-232 Serial Communications
Figure 2-32 RS-422 Connection to a Computer
Do not use an RS-422 port unless you are using equipment with RS-422 capability. The
Figure 2-33.
Section 2: Installation and Setup
2-23