Stacking Procedure - Christie Mirage S+/HD/WU User Manual

Section 2: Installation and Setup

2.2.3 Stacking Procedure

NOTES: 1) Requires stacking hardware provided standard with Roadsters only. Available separately for
Matrix and Mirage Series. 2) Installation requires at least 2 people.
Roadster, Matrix, and Mirage projectors can be stacked in either the upright or inverted position. Do not
mix orientations (i.e., inverted with upright) in a stack. Secure a maximum of 3 projectors with the stacking
mounts as described below.
or death.
1. Position the projectors.
• Place each projector to be stacked on a secure
table or cart.
• Place 1 projector on its side to access its adjust-
able feet, and stacking legs
• Orient the other projector in either upright or
inverted position as required (remember, each
projector in a stack must be in the same orienta-
tion).
2. Fully retract the 4 adjustable feet.
Fully retract each foot (4) as far as possible by
turning them clockwise.
• If upright, retract the feet on top projector.
• If inverted, retract the feet on bottom projector
2-8
• Maximum stack = 3 projectors
• Stack first, then hoist
Do not stack more than 3 projectors.
Christie stacking hardware required. The top projector could slide off and cause injury
Never carry a stack.
(Figure 2-11).
Figure 2-11 Adjust the Feet
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-06 Rev. 1 (04-2011)