Displaying Statistics - Foundry Networks FESX Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX

Displaying Statistics

To display statistics on most Foundry devices, enter a command such as the following at any level of the CLI:
FastIron SuperX Router(config-if-e1000-1/5-vrid-1)# show ip vrrp statistic
Interface ethernet 1/5
rxed vrrp header error count = 0
rxed vrrp auth error count = 0
rxed vrrp auth passwd mismatch error count = 0
rxed vrrp vrid not found error count = 0
VRID 1
rxed arp packet drop count = 0
rxed ip packet drop count = 0
rxed vrrp port mismatch count = 0
rxed vrrp ip address mismatch count = 0
rxed vrrp hello interval mismatch count = 0
rxed vrrp priority zero from master count = 0
rxed vrrp higher priority count = 0
transitioned to master state count = 1
transitioned to backup state count = 1
The same statistics are listed for VRRP and VRRPE.
Syntax: show ip vrrp brief | ethernet [<slotnum>/]<portnum> | ve <num> | statistic
Syntax: show ip vrrp-extended brief | ethernet [<slotnum>/]<portnum> | ve <num> | stat
The brief parameter displays summary information. See "Displaying Summary Information" on page 22-19.
If you specify a port, the <slotnum> parameter is required on chassis devices.
The <portnum> parameter specifies an Ethernet port. If you use this parameter, the command displays detailed
VRRP or VRRPE information only for the specified port. See "Displaying Detailed Information" on page 22-20.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command displays detailed
VRRP or VRRPE information only for the specified virtual interface. See "Displaying Detailed Information" on
page 22-20.
The statistic parameter displays statistics. This parameter is required for displaying the statistics.
This display shows the following information.
This Field...
Interface Statistics
Interface
rxed vrrp header error count
rxed vrrp auth error count
22 - 26
Table 22.6: CLI Display of VRRP or VRRPE Statistics
Displays...
The interface on which VRRP or VRRPE is configured. If VRRP or
VRRPE is configured on more than one interface, the display lists the
statistics separately for each interface.
The number of VRRP or VRRPE packets received by the interface
that had a header error.
The number of VRRP or VRRPE packets received by the interface
that had an authentication error.
© Foundry Networks, Inc. December 2005