Entering Programming Mode - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
___________________________________________________________________________________
1 - 8
Table 1-2 Multiline Terminal Keys Used for Programming
Key
B
This key is used to enter a pause, hyphen, asterisk or pound. To enter
an asterisk or pound:
B
B
B
B
B
The Message Waiting LED turns on and off after
E
Used to exit the programming mode (go back on-line).
G
Used to write (save) data. After entering data, press
written into memory. The next Memory Block is displayed.
2.5.3

Entering Programming Mode

The following digital Multiline Terminals can be used to program the
system. Station ports 01 and 02 are automatically assigned as
programming stations.
DTH/DTP/DTR-8D-1 TEL
DTU-8D-2 TEL
DTH/DTP/DTR-16D-1 TEL
DTU-16D-2 TEL
DTH/DTP/DTR-32D-1 TEL
DTU-32D-2 TEL
Using the DTH-16LD -1 TEL to program is not
recommended.
To enter programming mode, the station must be idle (on-hook).
Perform the following procedure to go off-line.
1. Press
2. Press
Description
J
+ =
,
L
+ =
#
A
+ = A
B
+ = B
C
+ = C
A
.
H
.
J L
o r i s pressed.
G
; the data is
Multiline Terminal Programming
Elite IPK