Section 3 How To Enter Programming Mode - NEC SL 1000 Programming Manual

SL1000/SL1100
2 15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message "15-07-01 TEL" on the first line of the telephone display. This indicates the pro-
gram number (15-07), item number (01), and that the options are being set for the extension. The sec-
ond row of the display "KY01 =
The third row allows you to move the cursor to the left or right, depending on which arrow is pressed.
To learn how to enter the programming mode, refer to
S
ECTION
To enter programming mode :
1 Go to any working display telephone.
In a newly installed system, use extension (port 1).
2 Do not lift the handset.
3 Press Speaker.
4 #
*
5 Dial the system password + Hold. Refer to the following table for the default system passwords. To
1-2
Downloaded from www.Manualslib.com
15-07-01 TEL200
KY01 =
(Multiline Telephone) (SL1000)
15-07-01
KY01 = *01
15-07-01
KY01 = *01
01" indicates that Key 01 is being programmed with the entry of
*
3 HOW TO ENTER PROGRAMMING MODE
# .
*
manuals search engine
*01
TEL
- +
(IP Phone) (SL1000)
TEL
- +
(SL1100)
How to Enter Programming Mode on this
ISSUE 1.0
01.
*
page.
Introduction