Did Limit To Tenant Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
2-09

DID Limit to Tenant Assignment

General Description
Use this Memory Block to assign the number of DID calls allowed to ring at a specified
tenant.
Display
T e n a n t D a t a
N o . N o .
0 0 : 0 9 : L I M I T
T I M E
Programming Procedures
1 Go off-line.
K I
2 Press LK2 +
3 Enter Setting Data using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
G
~ to enter numeric data
4 Press to write the data. The next Tenant No. for Memory Block 2-01 is displayed.
E
5 Program all Tenants. After Tenant 47 is programmed, the display cycles back to Tenant 01 of Memory Block 2-01.
6 Press to go back on-line.
Only DID incoming calls are limited. Outgoing calls, Internal (ICM) calls, and normal incoming calls are not
limited.
___________________________________________________________________________________
2 - 378
S e t t i n g
T i t l e D a t a 0 0 ~ 6 4
0 0
D I S P L A Y
to access the Memory Block.
Notes
System Mode
2
Submode
—
Data No.
09
PC Programming
+ BN
Default Values
00 (No Limit)
01~64 Incoming Calls
Programming Manual
Elite IPK