Did Digit Conversion Table - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-1-22

DID Digit Conversion Table

General Description
Up to 200 incoming DID numbers can be assigned individually to ring at a preassigned
2-digit, 3-digit, or 4-digit station number, closed number (plus outgoing digits), or
tenant number (00~47) for day mode or night mode. This Memory Block applies to the
DID number after it is modified by Memory Block 5-00 (Digit Add/Del for Tie Line
Networking Assignment).
Display
D a t a D i g i t s
N o . R e c e i v e d
2 2 :
DNIS Data
Settings
LK 1 LK 2
T
(Station or TN
Closed (Tenant)
Number)
Programming Procedures
1 Go off-line.
B B
2 Press LK1 + LK1 +
3 Press Line Key to select Station or closed number or tenant.
Enter the data using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
to enter numeric data or name (Refer to
~
B
Section 1 Character Assignment on page
H
to switch between Day and Night
C
to clear all data
to assign the name (Refer to Dial Pad Entry chart)
Digits Received: 0000~9999
Setting Data:
Station No. is a 2-, 3-, or 4-digit number (10~99, 100~999, or 1000~9999).
Closed Number is a 2-, 3-, or 4-digit number to facilitate routing to the closed
number.
Tenant No. 00~47
DNIS Data: 8-character maximum
___________________________________________________________________________________
Programming Manual
S e t t i n g
M o d e
D a t a
D Y = T
LK 3 LK 4 LK 5
to access the Memory Block.
B-1.)
LK 6 LK 7
Appendix B Character Codes,
Document Revision 1
System Mode
1
Submode
1
Data No.
22
PC Programming
+ALN
LK 8
Default not
assigned
Default Values
Not Specified
2 - 25