Section 2: PCB Installation and Startup
Initial Programming (Figure 2-17)
The system can be programmed using the following methods:
●
Through a digital keyset
●
Web Programming
Refer to the Aspire Software Manual (P/N 083200) for complete details on programming.
Entering the Programming Mode
Enter the system programming mode at extension 301:
1.
2.
3.
4.
Port Defaults
With the default settings, the ports are assigned as follows:
Making Test Calls
In the initial configuration:
●
All Programmable Function keys are line keys (e.g., key 1 is line 1).
●
All trunks are loop start DTMF.
2-42 ◆ Section 2: PCB Installation and Startup
Refer to the PCPro/WebPro Installation Manual, P/N 0893201, for complete installation details.
Press CALL1. (You hear dial tone).
Dial # * # *.
Dial the system password.
Press HOLD.
Station Ports:
Virtual Station Ports:
Trunk Ports:
Password
Level
12345678
2 (IN)
0000
3 (SA)
9999
4 (SB)
1-26 (extensions 301-499 and 5000-5312)
1-24 (extensions not assigned)
1-8
Aspire S Hardware Manual