NEC Electra Elite IPK Programing Manual page 324

Elite IPK
___________________________________________________________________________________
1-10-20 Call by Call Outgoing SFG
Assignment
General Description
Use this Memory Block to specify the outgoing call service assignment for the
Simulated Facility Group (SFG).
Display
S F G D a t a
N o .
0 1 ~ 1 6
0 1 / 2 0 : O G
T I M E
Programming Procedures
1 Go off-line.
J J B K
2 Press LK1 + LK10 +
3 Enter data using the dial pad.
Use the following to enter data:
J L
and
D
K I
~ to enter data
to select next SFG No.
Setting Data = 01~64
G
= 99 (Not Specified)
4 Press to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 1-10-21 and 1-10-22. The next SFG is displayed.
6 Repeat Steps 3, 4, and 5 for each SFG. After SFG 16 data is programmed, RAB 1 of Memory Block 1-10-00 is displayed.
7 Program the cycle again or press
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
1-1-30
Route Advance Block Assignment
1-1-46, 47, 48 Access Code (1-, 2-, or 3-Digit) Assignment
1-10-00 Call by Call Type of Network ID Assignment
1-10-01 Call by Call ID Plan Assignment
1-10-02 Call by Call Type of Number Assignment
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e D a t a
= 9 9
D I S P L A Y
to access the Memory Block.
to move the cursor
E
to go back on-line.
Document Revision 1
System Mode
1
Submode
10
Data No.
20
PC Programming
+AY
Default Values
All SFGs 99
2 - 253