NEC Electra Elite IPK Programing Manual page 470

Elite IPK
___________________________________________________________________________________
Programming Procedures
3 Press the corresponding CO/PBX line key to change incoming signal detect time for CO/PBX No.
Receiving Side
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or CO/PBX No.
D
– OR –
C
to go to the next assigned CO/PBX No.
A
to go to the next page.
G
to go to the previous page.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
3-14 Tie/DID Line Type Assignment
1. For second dial tone and immediate loop supervision, the time is fixed at 30 ms.
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
___________________________________________________________________________________
Programming Manual
Incoming Signal Detection
Sending Acknowledgment Signal
E
to go back on-line.
Time
Notes
Document Revison 1
DC Loop Supervision
2 - 399