Trunk-To-Trunk Group Assignment - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
3-03

Trunk-to-Trunk Group Assignment

General Description
Use this Memory Block to assign a Trunk Group Number (01~32) to each CO/PBX
line.
Display
C O / P B X
N o . D a t a
( 0 1 ~ 6 4 )
N o .
0 1 / 0 3 : T R K
T I M E
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Enter data for CO/PBX No. 01 using the dial pad to change the Trunk Group
number.
Use the following enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or CO/PBX No.
D
– OR –
to go to the next assigned CO/PBX No.
Trunk Group No.:
00: Not Set
G
01~32: Trunk Group 01~32
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
1. When a Trunk group Access Code is dialed, an idle CO line is selected automatically and seized from the same
Trunk group dialed (the CO line of either same tenant or another tenant can be seized).
2. By specifying the priority order, up to four routes (Trunk groups) can be selected in Memory Block 1-1-30 (Route
Advance Block Assignment). Idle CO lines are selected and seized in this sequence.
3. When LCR is installed, Local Trunks should be assigned to Trunk Group 1. When a number is dialed that
bypasses LCR, the system accesses Trunk Group 1 and dials the number.
___________________________________________________________________________________
Programming Manual
T r u n k G r o u p
T i t l e N o . ( 0 1 ~ 3 2 )
G P = 0 1
D I S P L A Y
K C
t o access the Memory Block.
E
to go back on-line.
Default Values
Notes
Document Revison 1
CO/PBX Line Mode
Submode
Data No.
03
PC Programming
+BCT
CO/PBX lines (01~08) in Trunk Group 01
CO/PBX lines (09~64) in Trunk Group 00
All Tie lines in Trunk Group 02
All DID lines Trunk Group 00
3
—
2 - 381