Tie Line Type Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
3-14

Tie Line Type Assignment

General Description
Use this Memory Block to assign the loop supervision to be used for each Trunk
associated with a Tie line.
Display
T i e / D I D
N o . D a t a
N o .
( 0 1 ~ 6 4 )
0 1 / 1 4 : 2 N D
T I M E
Settings
LK 1 LK 2
2ND DIAL IMMEDIATE
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
3 Press the corresponding CO/PBX line key to change the loop supervision for CO/PBX No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
3-92 Trunk (Installed, DP/DTMF) Selection
___________________________________________________________________________________
2 - 390
T i t l e
D I A L
D I S P L A Y
LK 3 LK 4
DELAY WINK
A D
+ t o access the Memory Block.
E
LK 5 LK 6 LK 7
to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
14
PC Programming
+ALT
LK 8 The shaded
selection is the
default.
Programming Manual
Elite IPK