1-14-02 Ars Dial Allow/Deny Selection - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________

1-14-02 ARS Dial Allow/Deny Selection

General Description
Use this Memory Block to specify whether or not to Allow digits that are entered in the
ARS dialing assignment to be routed using the ARS feature.
Display
T a b l e
N o .
D a t a
1 ~ 4
N o .
0 2 : 1 / 0 1
T I M E
Settings
LK 1 LK 2
YES NO
Programming Procedures
1 Go off-line.
K B
2 Press LK1 + LK14 +
3 Press the corresponding CO/PBX line key to change the Setting Data option.
Use the following to enter data:
K I
~ to select data
J
t o move cursor left
L
G
t o move cursor right
4 Press to write the data. The next Dial No. is displayed.
5 Repeat Steps 3 and 4 for each Dial No. (01~C8) for Table 1. After Dial No. C8 is programmed, the next Table No. is displayed.
6 Repeat Programming cycle for each Dial No.(01~C8) for Tables 2~4. The next Memory Block is displayed.
7 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-1-30 Route Advance Block Assignment
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ARS Allow/Deny Selection
1-14-01 ARS Dial Allow/Deny Selection
___________________________________________________________________________________
2 - 288
D i a l
S e t t i n g
N o . D a t a
T i t l e
A / D Y E S
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
LK 6 LK 7
to go back on-line.
System Mode
1
Submode
14
Data No.
02
PC Programming
+AB
LK 8 The shaded
selection is the
default.
Memory Blocks
Elite IPK