NEC Electra Elite IPK Programing Manual page 705

Document Revison 1
___________________________________________________________________________________
Time
CO/PBX Incoming
Ringing Alarm Time
Selection
Tie Line Delay
Ringing Time
Selection
Station Transfer/
Camp-On Recall
Time Selection
Trunk Queuing
Timeout Selection
CO/PBX Prepause
Time Selection
Hold Recall Time
Selection
(Exclusive)
Attendant Add-On
Console Transfer/
Camp-On Recall
Time Selection
First Delay
Announcement
Start Time Selection
First to Second
Delay
Announcement
Interval Time
Selection
___________________________________________________________________________________
A - 2
Table A-1 Function Time Chart (Continued)
Memory
Definition
Block
1-1-06 The time after an incoming
CO/PBX call is detected before
the ringing tone changes to a
different ringing tone level
when the call is not answered.
1-1-07 The time between when a
telephone rings (accessed by a
ringing call in the Tie/DID line)
and calls can start ringing at
other assigned stations when it
is not answered.
1-1-12 The time before a ring
transferred call recalls to the
station that transferred the call.
1-1-37 The time a station with Trunk
Queue set rings before the
queue is automatically
canceled.
1-1-57 The time before dialed digits
are sent over a CO/PBX line
after the line is seized.
1-1-63 The time (minutes) for
Exclusive Hold Recall. No limit
disables this feature.
1-1-64 The time (minutes) before a
ring transfer or a station camp-
on from a station with an
Attendant add on console
recalls to the originating station
if unanswered.
1-1-71 The time (seconds) between
receiving an incoming CO call
and sending the First Delay
Announcement to the caller.
1-1-73 The time (seconds) between
the end of the First Delay
Announcement and the
beginning of the second
Second Delay Announcement.
Value
Minimum Default
∞
10s
∞
10s
25s 45s
10s 10s
NON 1s
0.5 1.0
0.5 1.0
00 20
00 20
Function Time Chart
Elite IPK
Maximum
∞
∞
∞
60s
13s
∞
10.0
60
∞