NEC Electra Elite IPK Programing Manual page 59

Document Revison 1
___________________________________________________________________________________
LK 1 System Mode
LK 15 K-CCIS (Continued)
Data
Memory Block Name
No.
07 K-CCIS Message Response
Timeout Assignment
08 Link Reconnect Allow/Deny
Selection
09 K-CCIS Maximum Call Forwarding
Hop Assignment
10 Calling Name display Allow/Deny
Selection
11 Centralized Billing Allow/Deny
Selection
12 Centralized Billing – Point Code of
Center Office Assignment
13 Centralized Day/Night Switching for
Remote Office Assignment
14 Centralized Day/Night Switching for
Main Office Assignment
LK 1 System Mode
LK 16 HUB
Data
Memory Block Name
No.
00 Auto Negotiation Yes/No Selection
01 Port Speed Selection – 10/100
Base-T
02 Port Duplex Mode Selection
03 MDI/MDIX Mode Selection
04 VLAN Mode Selection
05 Default VLAN ID Assignment
06 Port Based Priority Selection
___________________________________________________________________________________
1 - 28
Default Value
30 sec
YS
5
NO
NO (Deny)
Blank
NO (Deny)
All Tables Not
Specified
Default Value
YS (Enable)
100 (100 Base-TX)
HALF
AUTO
NO (Disable)
0001 (0x001 Hex.)
NO (Not Assigned)
Programming Values
Valid Times: 01~99 Seconds
NO, YS
1~7
NO, YS
NO (Deny), YS (Allow)
Point Code Range: 00001~16367
NO (Deny), YS (Allow)
Table Range: 01~16
Point Code Range: 00001~16367
Programming Values
YS, NO
(100 Base-TX)
10 (10 Base-T), 100
HALF, FULL
MDIX, MDI, AUTO
NO, YS (Enable)
0001~4095 (0x001~0xfff Hex.)
NO, LO (Low), HI (High)
Multiline Terminal Programming
Elite IPK