Private Line Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-1-29

Private Line Assignment

General Description
Use this Memory Block to assign an outside line as a private line. The private line
cannot be seized by any other telephone, and an LED indication is not provided to
other terminals.
Display
C o m b i n a t i o n
D a t a
T i t l e
N o .
2 9 : P
T I M E
Programming Procedures
1 Go off-line.
B I
2 Press LK1 + LK1 +
3 Enter the data using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
H
K I
to enter numeric data
~
G
to clear all data when cursor is at CO No. or Tel. Port No.
G
4 Press to write the data. Data for the second line is displayed. Move the cursor to change the data.
5 Press to write the data and display the next Memory Block.
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
2-06 Line Key Selection for Tenant Mode
4-12 Line Key Selection for Telephone Mode
1. Two private lines can be assigned to one station or one private line can be assigned to two stations.
2. A Single Line Telephone (SLT) user cannot dial the Trunk Group Access Code to access a private line. The
Single Line Telephone user can dial the specified Line Seizure Access Code assigned in Memory Blocks 1-1-46/
1-1-47 [Access Code (1-digit/2-digit) Assignment], Function 063 or 064 to access the line.
3. When a station is allowed Barge-In originate, and a second station is allowed Barge-In receive, Barge-In is not
allowed on a private line unless both stations share the private line.
___________________________________________________________________________________
2 - 36
C O N o .
T e l . P o r t N o .
N o .
( 0 1 ~ 6 4 )
( 0 1 ~ C O )
( 1 / 2 )
1 C = T =
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Notes
Elite IPK
System Mode
1
Submode
1
Data No.
29
PC Programming
+BCS
Default Values
Not Specified
Memory Blocks