NEC Electra Elite IPK Programing Manual page 707

Document Revison 1
___________________________________________________________________________________
Time
Hookflash Start
Time Selection
Hookflash End
Time Selection
Voice Mail DTMF
Delay Time
Selection
Voice Mail
Disconnect Time
Selection
Voice Mail DTMF
Duration/Interdigit
Time Selection
Tandem Transfer
Automatic
Disconnect Time
Selection
Automated
Attendant First Digit
PBR Release Time
Selection
Automated
Attendant Transfer
Delayed Ringing
Time Selection
Automated
Attendant No
Answer Disconnect
Time Selection
Automated
Attendant Answer
Delay Time
Assignment
___________________________________________________________________________________
A - 4
Table A-1 Function Time Chart (Continued)
Memory
Definition
Block
1-3-05 The minimum hookflash time
(milliseconds) for a Single Line
Telephone or Voice Mail
System before a valid
hookflash is detected.
1-3-06 The maximum hookflash time
from a Single Line Telephone to
receive a second dial tone
(HST = Hookflash Start Time).
1-3-08 The delay time before DTMF
tones are sent from the VMI
port.
1-3-09 The time a disconnect signal is
sent to Voice Mail equipment.
1-3-10 The DTMF duration/interdigit
time (milliseconds) for voice
mail.
1-4-00 The maximum time (minutes)
before the system automatic
disconnects a Trunk-to-Trunk
connection.
1-4-01 The time a PBR circuit remains
connected after the Automated
Attendant message is played
when a call comes in through
an Automated Attendant trunk.
1-4-02 The time a call rings at the
destination before the
Automated Attendant rings a
predetermined station.
1-4-03 The time the Automated
Attendant rings a station before
automatic disconnect.
1-4-13 The time before the Automated
Attendant answers an incoming
CO/PBX call.
Value
Minimum Default
40 290
00 07
(HST + 0 (HST + 700
ms.) ms.)
0s 1s
0.5s 1.5s
60/70 110/80
000 060
5s 20s
∞
10s
1m 2m
00s 04s
Function Time Chart
Elite IPK
Maximum
790
15
(HST +
1500 ms.)
8s
3.5s
810/190
999
60s
∞
4m
99s