NEC Electra Elite IPK Programing Manual page 521

Document Revison 1
___________________________________________________________________________________
Page 7 – Trunks 49~56
LK 1 LK 2
49 50
Page 8 – Trunks 57~64
LK 1 LK 2
57 58
Programming Procedures
1 Go off-line.
2 Press LK4 to access the Memory Block.
3 Press the CO/PBX Line key to select Day ring assignment for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX line key is pressed.
CO/PBX
Line Key LED
Data
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or Tel Port No.
D
– OR –
C
to go to next assigned Tel Port No.
A
to go to the next page
G
to go to the previous page
4 Press to write the data and display Memory Block 4-02.
5 After programming Memory Blocks 4-02~4-59, the next sequential Tel Port No. is automatically displayed.
E
6 Repeat steps 3, 4, and 5 until all Tel Port Nos. are programmed. Tel Port No. 01 is displayed again.
7 Press to go back on-line.
Telephone ports A0~C0 are ports 100~120. Refer to Settings 1 to enter ports A0~C0.
___________________________________________________________________________________
2 - 450
LK 3 LK 4
51 52
LK 3 LK 4
59 60
Off Green
Immediate
No ring
Ring
LK 5 LK 6 LK 7
53 54
LK 5 LK 6 LK 7
61 62
Red
Delayed Ring
Notes
LK 8
55 56
LK 8
63 64
Default Values
CO/PBX lines 01 ~ 08 ring at Tel Port
numbers 01 and 02.
Tel Port numbers 03 ~ 120 do not ring
on any incoming CO/PBX calls.
Memory Blocks
Elite IPK