Section 2 Programming Mode; Entering The Programming Mode; Exiting The Programming Mode; Figure 3-6 Entering Programming Mode Display 1 - NEC SL1100 Hardware Manual

SL1100

SECTION 2 PROGRAMMING MODE

2.1

Entering the Programming Mode

The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial # * # *.
3. Dial the system password, then press Hold key to enter the Program Mode.
For the details of programming, refer to the SL1100 Programming Manual. (separate issue)
2.2

Exiting the Programming Mode

1. Press Mute key several times to return to the "Program Mode" Screen.
2. Press Speaker key to exit.
The system automatically saves the customer data to the memory which is backed up by lithium
battery.
3-4

Figure 3-6 Entering Programming Mode Display 1

Figure 3-7 Entering Programming Mode Display 2

Figure 3-8 Exiting the Programming Mode Display 1

Figure 3-9 Exiting Programming Mode Display 2

ISSUE 1.0
System Start Up