NEC Electra Elite IPK Programing Manual page 614

Elite IPK
___________________________________________________________________________________
4-94 3-Minute Alarm Selection
General Description
Use this Memory Block to specify per station whether or not a warning tone is
generated at 3-minute intervals during an outgoing or incoming CO/PBX call.
Display
T e l
P o r t
D a t a
N o .
( 0 1 ~ C 0 )
N o .
0 1 / 9 4 : 3 m A L M
T I M E
Settings
LK 1 LK 2
NO YS
Programming Procedures
1 Go off-line.
I D
2 Press LK4 +
3 Press LK2 to generate a three-minute warning tone during a call for Tel port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or Tel Port No.
D
– OR –
B
to go to next assigned Tel Port No.
B
A
+
B B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
1. A 1-second (approximately) warning signal sounds every three minutes during CO/PBX calls.
2. The alarm tone is heard through the terminal speaker only.
3. When the built-in speakerphone is used for handsfree, the warning signal is not used.
4. Telephone ports A0~C0 are ports 100~120.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e D a t a
N O
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
LK 6 LK 7
to go back on-line.
Notes
Document Revison 1
Telephone Mode
4
Submode
—
Data No.
94
PC Programming
+BTM
LK 8 The shaded
selection is the
default.
2 - 543