NEC Electra Elite IPK Programing Manual page 352

Elite IPK
___________________________________________________________________________________
1-13-04 PRT B Channel Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for the B-channels when calls
are originated on a PRT(1)-U( ) ETU.
This assignment is allowed by handset programming and SAT.
Display
P R T
D a t a
1 ~ 8 N o .
0 1 / 0 4 : C H
T I M E
Settings
LK 1 LK 2
H → L L → H
High to Low Low to High
Programming Procedures
1 Go off-line.
K D
2 Press LK1 + LK13 +
G
3 Press the corresponding CO/PBX line key to change the data option.
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-13-00
PRT Channel Assignment
1-13-01
PRT Signal Format Selection
1-13-03
Call by Call Service Selection
1-13-05 PRT B Channel-to-Trunk Group Assignment
5-06 Trunk Group Outgoing Priority Selection
This Memory Block applies to all firmware versions of the PRT(1)-U( ) ETU.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
T i t l e
>
S L C = H
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
L
LK 6 LK 7
Notes
Document Revision 1
System Mode
1
Submode
13
Data No.
04
PC Programming
+AN
LK 8
The shaded
selection is the
default.
2 - 281