Tandem Transfer Smdr Print Extension Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-4-04 Tandem Transfer SMDR Print
Extension Assignment
General Description
Use this Memory Block to specify a special number to be output from Station Message
Detail Recording (SMDR) to indicate an automatic trunk-to-trunk transfer.
Display
D a t a
N o .
0 4 : T A N D
T I M E
Programming Procedures
1 Go off-line.
J D
2 Press LK1 + LK4 +
3 Use the dial pad to enter the Table Number and Setting Data.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
Setting Data (Allowed):
2-Digit Number: 00~99
3-Digit Number: 000~999
G
4-Digit Number: 0000~9990
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-2-03 2-, 3-, or 4-Digit Station Number Selection
1. When the system is powered up initially, this block defaults to 3-digit number 999.
2. When 2-digit station numbers are selected, this block defaults to 99.
3. When 4-digit station numbers are selected, this block defaults to 9999.
___________________________________________________________________________________
2 - 134
S e t t i n g
T i t l e
D a t a
E X T = 9 9 9
D I S P L A Y
t o access the Memory Block.
E
to go back on-line.
Default Values
Notes
System Mode
Submode
Data No.
PC Programming
3-digit number = 999
Memory Blocks
Elite IPK
1
4
04
+AT