NEC Electra Elite IPK Programing Manual page 335

Document Revison 1
___________________________________________________________________________________
1-11-06 Signaling Selection
General Description
Use this Memory Block to specify Loop Start (LS) or Ground Start (GS) Trunk
Signaling when using T1.
Display
D T I N o . D a t a
( 0 1 ~ 0 8 ) N o .
0 1 / 0 6 : T R N K 0 1 = L S
T I M E
Settings
LK 1 LK 2
LS GS
Programming Procedures
1 Go off-line.
K F
2 Press LK1 + LK11 +
G
3 Press the corresponding CO/PBX line key to change the data option.
4 Press to write data and advance to the next Channel No.
5 Repeat Steps 3 and 4 for each Channel No. The next Memory Block is displayed.
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-11-07 DTI Trunk Type Assignment
7-1 Card Interface Slot Assignment
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
___________________________________________________________________________________
2 - 264
S e t t i n g
C h a n n e l
D a t a
N o .
T i t l e
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7
Notes
System Mode
1
Submode
11
Data No.
06
PC Programming
+AD
LK 8 The shaded
selection is the
default.
Memory Blocks
Elite IPK