Automatic Day/Night Mode Switching Time Assignment - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-1-27 Automatic Day/Night Mode Switching
Time Assignment
General Description
Use this Memory Block to assign a start time for Pattern 1 and a different start time for
Pattern 2 to automatically switch between Day Mode and Night Mode.
Display
P a t t e r n
D a t a
N o . ( 1 / 2 )
2 7 : 1
T I M E
Programming Procedures
1 Go off-line.
B G
2 Press LK1 + LK1 +
3 Enter the data using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
H
K I
to enter numeric data
~
G
to clear all data when the cursor is in the Data No. position.
4 Press to write the data. The switching time for pattern 2 is displayed.
G
5 Use the dial pad to change the time.
6 Press to write the data and display the next Memory Block.
7 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-32 Automatic Day/Night Mode by Day of Week Selection
1-4-05 Automatic Tandem Trunk by Night Mode Selection
1-8-07 Class of Service (Attendant) Feature Selection I
1-8-48 Automatic Daylight Saving Time Selection.
4-07 Code Restriction Class Assignment (Day Mode)
4-08 Code Restriction Class Assignment (Night Mode)
4-09 Telephone to Tenant Assignment
___________________________________________________________________________________
Programming Manual
D a y M o d e N i g h t M o d e
S t a r t T i m e
S t a r t T i m e
S e t t i n g S e t t i n g
D a t a D a t a
: , :
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Document Revision 1
System Mode
1
Submode
1
Data No.
27
PC Programming
+BM
Default Values
Not Specified
2 - 33