NEC Electra Elite IPK Programing Manual page 519

Document Revison 1
___________________________________________________________________________________
3-92 Trunk (Installed, DP/DTMF)
Selection
General Description
Use this Memory Block to specify an external line as DP (10 pps or 20 pps), DTMF
line, or not connected (NIL).
Display
C O / P B X
D a t a
N o .
N o .
( 0 1 ~ 6 4 )
0 1 / 9 2 : M F
T I M E
Settings
LK 1 LK 2
NIL DP 10pps
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
3 Press line key to specify external line as DP or DTMF for CO/PBX No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the selected data and display the next CO/PBX No. for Memory Block 3-90. After CO/PBX No. 64 is
entered, CO/PBX No. 01 is again displayed on Memory Block 3-90.
Related Programming
M.B. Number Memory Block Name
Tie Line Type Assignment
3-14
Line Key Selection for Telephone Mode
4-12
Only Tie lines and Direct Inward Dialing (DID) trunks can use dial pulse on the Electra Elite system. All other
trunks must be set to multifrequency (MF).
___________________________________________________________________________________
2 - 448
S e t t i n g
D a t a
D I S P L A Y
LK 3 LK 4
DP 20pps MF
I B
+ to access the Memory Block.
LK 5 LK 6 LK 7
Notes
Elite IPK
CO/PBX Line Mode
3
Submode
—
Data No.
92
PC Programming
+BCT
LK 8 The shaded
selection is the
default.
Programming Manual