Flow Control For Full Duplex Selection - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-16-16 Flow Control for Full Duplex
Selection
General Description
Use this Memory Block to specify whether or not Full duplex IEEE802.3x Flow Control
is enabled for each HUB(8)-U( ) ETU port.
Display
D a t a H U B
N o . 1 ~ 3
1 6 : 1 - 1
T I M E
Settings
LK 1 LK 2
NO YS
Programming Procedures
1 Go off-line.
A F
2 Press LK1 + LK16 +
G
3 Press the corresponding CO/PBX line key to change the option.
4 Press to write the data.
E
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU port.
6 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
S e t t i n g
P O R T
T i t l e T i t l e D a t a
1 ~ 8
F L O W N O
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
LK 6 LK 7 LK 8
Document Revision 1
System Mode
1
Submode
16
Data No.
16
PC Programming
+AB
The shaded
selection is the
default.
3 - 365