Xn120 Configuration Mode - NEC EXIFU-A1 Installation, Configuration And Operation

XN120 Configuration Mode

Entering Configuration Mode
·
You will need an XN120 system phone with an LCD display.
·
The phone should be idle (no call in progress).
1 Press SPK
(do not lift the handset)
2 Dial Service Code # * # *
3 Dial password 12345678
4 Press HOLD
Selecting the Program Number
·
Each configuration setting within the XN120 is identified by a Program Number (eg 22-05-01).
1 Ensure the LCD display
shows:
2 If it is not displayed press the
DC key several times.
3 Now enter the Program
Number e.g 22 05 01 with the
numeric keys of the XN120
phone.
Using the System Phone Keys to Make Changes
·
During configuration mode use the keys at the system phone to select the program item and change its
value etc.
· The LCD display will show the current program item, the editing point is shown by a flashing curser.
SPK
Numeric keys
1 to 9 * and #
HOLD
DC
DND/CONF
CLEAR
LND
OPAC
Vol. up
Vol. down
FLASH
XN120 EXIFU Guide
You will see -
You will see -
You will see -
You will see -
Save changes and exit configuration mode.
Alphanumeric entry keys. Entered at the curser location.
Confirm the entry and step on to the next.
Step back one level. Current entry is not confirmed.
Delete one character to the left of the curser.
Delete all characters to the right of the curser.
Move the curser one character to the left.
Move the curser one character to the right.
Confirm the entry and step to the next item shown at the top right of the display.
Confirm the entry and step to the previous item shown at the top right of the display.
Move the curser to the next entry point.
Configure the EXIFU Card
MON 27 16:28PM
200 EXT200
Password
Password@@@@@@@@
_
Program Mode
_
Program Mode
22-05-01 Trunk1
Mode1 IRG =1
11