NEC Electra Elite IPK Programing Manual page 60

Elite IPK
___________________________________________________________________________________
LK 1 System Mode
LK 16 HUB (Continued)
Data
Memory Block Name
No.
07 High Priority RX Tag Assignment
08 High Priority TX Tag Assignment
09 Low Priority TX Tag Assignment
10 Port Mirroring Selection
11 Mirroring Source Port Assignment
12 Mirroring Target Port Assignment
13 VLAN Group to VLAN ID
Assignment
14 VLAN Group and Port Selection
15 VLAN Tag Insertion Selection
16 Flow Control for Full Duplex
Selection
17 Back Pressure for Half Duplex
LK 2 Tenant Mode
Data
Memory Block Name
No.
01 Trunk to Tenant Assignment
05 Line Key Selection
06 Line Key Selection for Tenant Mode
07 System Speed Dial Display
Assignment
08 ECR Relay to Tenant Assignment
09 DID Limit to Tenant Assignment
___________________________________________________________________________________
Programming Manual
Default Value
7
7
0
NO (Normal)
Port 1
Port 1
0001(0x001)
NO
NO
NO
NO
Default Value
Refer to 2-01 Trunk to Tenant Assignment on page
TEL
Refer to 2-06 Line Key Selection for Tenant Mode on page
CO/PBX Line LED
On
All Speed Dial
Confirmation Allowed
All Tenants - No
Assignment
00
Document Revision 1
Programming Values
(Lowest) 0~7 (Highest)
(Lowest) 0~7 (Highest)
(Lowest) 0~7 (Highest)
NO, YS (Mirror)
Port range: 1~8
Port range: 1~8
0001~4095 (0x001~0xfff
ID Range:
Hex.)
NO, YS
NO, YS
NO, YS
NO, YS
Programming Values
2-369.
TEL (Telephone Mode)
TNAT (Tenant-Wide Mode)
On (Assigned)
Off (Not Assigned)
N/A
00 (no limit), 01~64 Incoming Calls
2-372.
1 - 29