Com Port Parity/Stop Bit Setting Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-8-36 COM Port Parity/Stop Bit Setting
Assignment
General Description
Use this Memory Block to specify the Parity and Stop bit for the individual COM ports.
Display
D a t a
N o .
3 6 : P / S
T I M E
Settings
LK 1 LK 2
NON/1 NON/2
Programming Procedures
1 Go off-line.
C F
2 Press LK1 + LK8 +
3
Press the corresponding CO/PBX line key to select the parity and stop bit setting
G
4 Press to write the data, and advance to the next COM port.
5 Repeat steps 3 and 4 for each remaining COM port. The next Memory Block is displayed.
6 Program next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-5-13 Printer Connected Selection
COM 1 = PC Programming
COM 1 = LCR
COM 2 = Station Message Detail Recording (SMDR)
COM 3 = Automatic Call Distribution [Not used by Electra Elite IPK Basic Port Package (48).]
___________________________________________________________________________________
2 - 218
S e t t i n g
T i t l e D a t a
1 = N O N / 1
D I S P L A Y
LK 3 LK 4
EVEN/1 ODD/1
to access the Memory Block.
E
to go back on-line.
LK 5 LK 6 LK 7
Notes
Electra Elite IPK
System Mode
PC Programming
LK 8 The shaded
selection is the
default.
. Default Values
COM 1 = Non/1
COM 2 = Non/1
COM 3 = Non/1
Memory Blocks
1
Submode
8
Data No.
36
+CSS