Section 2 Programming Mode; Entering The Programming Mode; Exiting The Programming Mode - NEC SL1100 Hardware Manual

SL1100
S 2 PROGRAMMING MODE
ECTION

2.1 Entering the Programming Mode

The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial # * # * .
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
3. Dial the system password, then press Hold key to enter the Program Mode.
Password@@@@@@@@
For the details of programming, refer to the SL1100 Programming Manual. (separate issue)

2.2 Exiting the Programming Mode

1. Press Mute key several times to return to the "Program Mode" Screen.
10-01-
Time&Date Setup
back
2. Press Speaker key to exit.
Base Service OP1 OP2
The system automatically saves the customer data to the memory which is backed up by lithium
battery.
3-4
Figure 3-6 Entering Programming Mode Display 1
Figure 3-7 Entering Programming Mode Display 2
Sys Config
|01
Select
Figure 3-8 Exiting the Programming Mode Display 1
Program Mode
Figure 3-9 Exiting Programming Mode Display 2
Password
Program Mode
Base Service OP1 OP2
Program Mode
Base Service OP1 OP2
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
ISSUE 4.1 (R5.1)
System Start Up