Master Clock Selection - NEC Electra Elite IPK Programing Manual

Electra Elite IPK
___________________________________________________________________________________
1-8-33

Master Clock Selection

General Description
When a DTI-U( ) ETU (T-1), PRT(1)-U( ) ETU, or BRT(4)-U( ) ETU is installed, clocking
must be synchronized. When this Memory Block is set for Cabinet 0 (default), the
system is set to be a Master Clock source. Programming this Memory Block defines
the system to be a slave from its connected source.
When the master clock selection is changed, press the Reset switch on the CPU to reset the
system.
Display
D a t a
N o .
3 3 : M S T R C L C K
T I M E
Programming Procedures
1 Go off-line.
C C
2 Press LK1 + LK8 +
3
Use dial pad to enter number of digits
Use the following to enter data:
K I
~ to enter digits
J
to move cursor left
L
G
to move cursor right
4 Press to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
Example 1: (Elite 100 is Master Clock Source)
MB 1-8-33
Setting
___________________________________________________________________________________
Programming Manual
S l o t
C a b i n e t
0 ~ 3 1 ~ 8
T i t l e
0 :
D I S P L A Y
to access the Memory Block.
.
E
to go back on-line.
Electra Elite
T1
DTI
Cabinet 1
Slot 1
(100)
Cabinet 0
Master
Electra Elite
T1
DTI DTI
Cabinet 1 Cabinet 1
Slot 1 Slot 4
(200)
Cabinet 1
Slot 1
(Slave)
Document Revision 1
System Mode
1
Submode
8
Data No.
33
PC Programming
+AD
Default Values
Cabinet 0 (Master System)
Electra Elite
DTI
Cabinet 1
Slot 1
(300)
Cabinet 1
Slot 1
(Slave)
2 - 215