NEC Electra Elite IPK Programing Manual page 546

Elite IPK
___________________________________________________________________________________
4-18 Station Name Assignment
General Description
Use this Memory Block to assign names for telephone stations.
Display
T e l
P o r t
N o . D a t a
N o .
( 0 1 ~ C 0 )
0 1 / 1 8 : <
T I M E
Programming Procedures
1 Go off-line.
A H
2 Press LK4 +
3 Use the dial pad to enter data.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
~ to enter numeric data or Tel Port No.
D
– OR –
H
to go to next assigned Tel Port No.
B
to clear data when cursor is at setting data
B
A
+
B
B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
1. While an internal line is ringing or in use, the station number and name of the other party are displayed.
2. The name is not displayed when Tone Override, Automatic Callback, or Callback Request is displayed.
3. Only six digits/characters can be used for each name.
4. Telephone ports A0~C0 are ports 100~120.
5. Refer to Appendix B Character
entering station names using the dial pad instead of the ASCII Character Code Tables.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
>
D I S P L A Y
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
to go back on-line.
Codes, Section 1 Character Assignment on page B-1
Default Values
Notes
Document Revison 1
Telephone Mode
Submode
Data No.
PC Programming
Not Specified
for the procedure for
4
—
18
+BTT
2 - 475